Guides
Written up after the call
If one of these gets your Wolf working again without a visit, that is a good outcome. If not, you will at least be able to describe the fault properly when you ring.
- Wolf Burner Clicks but Will Not Light: A Newton Walkthrough Clicking proves the spark module is firing and says nothing about gas arriving. Work out whether one burner or all of them are affected, check cap seating and port blockage, then treat any delay before ignition as urgent rather than an inconvenience. 6 min read Obi Nwachukwu
- Wolf Oven Door Locked After Self-Clean: A Newton Walkthrough A Wolf door still locked after self-clean is usually a latch waiting on the control's permission rather than a broken part. This Newton walkthrough explains the mechanism, separates a cool-down wait from a power failure, and says exactly where to stop. 6 min read Obi Nwachukwu
- Wolf Hood Running but Smoke Still Fills the Kitchen When a Wolf hood runs and smoke still fills the kitchen, the cause is often geometry: the plume from the front elements drifts out of reach before the canopy can collect it. Test with tissue at every speed and position, wash the baffles, then measure the overhang. 7 min read Obi Nwachukwu
Booking
Or let somebody with a meter look
Model number and a plain description. Most of these are half-diagnosed before anyone is on the road.
Flat $95 service call, credited against an approved repair — full details on the contact page.
What the repair itself costs
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it. Ranges, not quotes — your figure is agreed before anything is taken apart.
- Igniter or spark module replacement $270–$640
- Burner valve or orifice service $250–$1,110
- Oven thermostat or sensor calibration $140–$720
- Convection fan or motor $310–$910
- Control board or touch panel $500–$1,590
- Door hinge, glass or seal $210–$930