02459 · Newton, MA
Oak Hill
Newton's most suburban corner, with mid-century ranches and split-levels on wide lots south of Route 9. Kitchens here are usually original-footprint remodels, where a professional range has been fitted into a space framed for a standard 30-inch stove.
The most suburban corner of Newton: mid-century ranches and split-levels on wide lots south of Route 9. Kitchens are usually original-footprint remodels, where a pro range has been fitted into a wall that was framed for something narrower.
Recurring here
A range dropped into an older opening often ends up with tight clearances at the sides and behind. Heat that has nowhere to go shows up as knob bezels that are too hot to touch, and the fix is clearance and insulation rather than a part.
Booked from this postcode
What Oak Hill rings about
- Wolf Range Repair Wolf ranges in Newton kitchens, from the older all-gas sealed-burner models to current dual-fuel builds. Lighting and flame faults on the top, heat behaviour in the cavity below, and the controls the two share.
- Wolf Oven Repair Wolf wall ovens and range ovens, including convection and steam-assisted cavities. Sensor and element faults, door seal and hinge tension, self-clean behaviour and the board that drives it.
- Wolf Cooktop Repair Wolf gas, induction and electric cooktops set into island and perimeter counters. Ignition and spark, burner bases and grates, induction pan sensing, and the knobs or touch controls in front of them.
- Wolf Range Hood Repair Wolf hoods over Newton ranges — wall canopies, island hoods and pro models with internal or remote blowers. Motor and speed control, filter and duct restriction, lights and switching.
Next along
Reviews
From Oak Hill
4.9 out of 5 from 1,105 reviews
5 out of 5
Long duct out through the flat roof of a ranch. The fan slowed, then stopped. Motor windings gone, probably water in at the cap. New motor and a proper cap, and it draws well again.
Harriet B. · Oak Hill
5 out of 5
Baffle filters kept dropping out of the frame while I was cleaning them. The retaining rail was bent. He straightened it, fitted new clips and adjusted a light housing that had been knocked askew.
Duncan G. · Oak Hill
5 out of 5
The whole top shut down in the middle of a meal and threw a fault. The cooling fan under the counter was clogged with dust from the cabinet below. Cleaned, new fan, and it has run through several long dinners.
Renata J. · Oak Hill
Booking
Book a visit in Oak Hill
Model number and a plain description. Most of these are half-diagnosed before anyone is on the road.
Flat $95 service call, credited against an approved repair — full details on the contact page.
What the repair itself costs
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it. Ranges, not quotes — your figure is agreed before anything is taken apart.
- Igniter or spark module replacement $270–$640
- Burner valve or orifice service $250–$1,110
- Oven thermostat or sensor calibration $140–$720
- Convection fan or motor $310–$910
- Control board or touch panel $500–$1,590
- Door hinge, glass or seal $210–$930